MEMORIA RAM DDR3 1866 KINGSTON HYPERX FURY BLUE 2x8GB

MEMORIA RAM DDR3 1866 KINGSTON HYPERX FURY BLUE 2x8GB
Precio:
141.00
Comprar
  • Datos:
  • Nombre: MEMORIA RAM DDR3 1866 KINGSTON HYPERX FURY BLUE 2x8GB
  • Referencia: M08W
  • Código de barras: 0740617230598
  • Part Number: HX318C10FK2/16
  • Disponibilidad:
  • Artículo disponible en 1-2 días hábiles para envío.
  • Disponibilidad en tiendas:
  • Bilbao San Mamés: Artículo disponible en 1-2 días hábiles para recoger.
  • Bilbao San Ignacio: Artículo disponible en 1-2 días hábiles para recoger.

HyperX HX318C10FK2/16 is a kit of two 1G x 64-bit (8GB) DDR3-1866 CL10 SDRAM (Synchronous DRAM) 2Rx8 memory modules, based on sixteen 512M x 8-bit DDR3 FBGA components per module. Total kit capacity is 16GB. Each module kit has been tested to run at DDR3-1866 at a low latency timing of 10-11-10 at 1.5V. Additional timing parameters are shown in the PnP Timing Parameters section below. The JEDEC standard electrical and mechanical specifications are as follows:

PnP JEDEC TIMING PARAMETERS:
• DDR3-1866 CL10-11-10 @1.5V
• DDR3-1600 CL9-10-9 @1.5V
• DDR3-1333 CL8-9-8 @1.5V

SPECIFICATIONS
CL(IDD) 10 cycles
Row Cycle Time (tRCmin) 44.75ns (min.)
Refresh to Active/Refresh 260ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin) 32.125ns (min.)
Maximum Operating Power TBD W* (per module)
UL Rating 94 V - 0
Operating Temperature 0o C to 85o C
Storage Temperature -55o C to +100o C
*Power will vary depending on the SDRAM used.

FEATURES
• JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
• VDDQ = 1.5V (1.425V ~ 1.575V)
• 933MHz fCK for 1866Mb/sec/pin
• 8 independent internal bank
• Programmable CAS Latency: 13, 11, 10, 9, 8, 7, 6
• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
• 8-bit pre-fetch
• Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]
• Bi-directional Differential Data Strobe
• Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
• On Die Termination using ODT pin
• Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C < TCASE < 95°C
• Asynchronous Reset
• PCB : Height 1.180” (30.00mm), double sided component

Versión imprimible