MEMORIA RAM DDR3 1600 KINGSTON HYPERX FURY BLUE 4GB

MEMORIA RAM DDR3 1600 KINGSTON HYPERX FURY BLUE 4GB
Precio:
36.30
Comprar
  • Datos:
  • Nombre: MEMORIA RAM DDR3 1600 KINGSTON HYPERX FURY BLUE 4GB
  • Referencia: M08P
  • Código de barras: 740617230376
  • Part Number: HX316C10F/4
  • Disponibilidad:
  • Artículo disponible en 1-2 días hábiles para envío.
  • Disponibilidad en tiendas:
  • Bilbao San Mamés: Artículo disponible en 1-2 días hábiles para recoger.

CL10 SDRAM (Synchronous DRAM) 1Rx8 memory module, based on eight 512M x 8-bit DDR3 FBGA components. This module has been tested to run at DDR3-1600 at a low latency timing of 10-10-10 at 1.5V. Additional timing parameters are shown in the PnP Timing Parameters section below. The JEDEC standard electrical and mechanical specifications are as follows:

SPECIFICATIONS
CL(IDD): 10 cycles
Row Cycle Time (tRCmin): 48.125ns (min.)
Refresh to Active/Refresh Command Time (tRFCmin): 260ns (min.)
Row Active Time (tRASmin): 37.5ns (min.)
Maximum Operating Power: TBD W*
UL Rating: 94 V - 0
Operating Temperature: 0ºC to 85ºC
Storage Temperature: -55ºC to +100ºC
*Power will vary depending on the SDRAM used.

FEATURES
- JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
- VDDQ = 1.5V (1.425V ~ 1.575V)
- 800MHz fCK for 1600Mb/sec/pin
- 8 independent internal bank
- Programmable CAS Latency: 11, 10, 9, 8, 7, 6
- Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
- 8-bit pre-fetch
- Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]
- Bi-directional Differential Data Strobe
- Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
- On Die Termination using ODT pin
- Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C < TCASE < 95°C
- Asynchronous Reset
- PCB : Height 1.180” (30.00mm), single sided component

Versión imprimible